AGM Global Vision ANACONDA Series, User Manual

Page: 13 / 40

13 Anaconda
USER MANUAL
WARNING:
AGM recommends that you use an eyecup on the day scope’s eyepiece for maximum safety and
comfort, as well as to escape detection.
NOTE:
The optical axes of the Anaconda and day scope should be aligned. The distance between the
axes should not exceed 3 mm. If the difference in the axis heights of the Anaconda and day scope
above the weapon rail exceeds 3 mm, you will need to replace the day scope mounting rings or
monoblock.
The Anaconda comes fully assembled with a Picatinny/Weaver mount (Figure 2-2).
The mount is (A) coupled with a riser (B) and attached to the Anaconda seating rail (C) with two
M4×20 flathead socket cap screws (D).
FIGURE 2-2. THE ANACONDA FULLY ASSEMBLED WITH THE MOUNT
A
B
E
C
D
Figure 2-3 shows the Anaconda mounted in front of a day scope.
To install the Anaconda on a Picatinny/Weaver rail, do the following:
1. Unscrew the output lens cap and place it in the storage case.
2. Remove the light suppressor from the storage case. Screw it into the thread of the output lens
in place of the cap.
3. Unlock the clamping device (A) of the Anaconda mount by pushing down on the lever holder (B,
see Figure 2-4) and unlocking the cam lever (C).
4. Install the Anaconda on the Picatinny/Weaver rail in front of the day scope so that the stop (E,
see Figure 2-2) slides into one of the rail’s transverse slot. The light suppressor should cover the
day scope’s objective lens.
FIGURE 2-3. THE ANACONDA ON A PICATINNY RAIL IN FRONT OF A DAY SCOPE