Agilent Technologies Infiniium 8000A, Programmer'S Reference Manual

Page: 612 / 934

23-114
Measure Commands
TIEClock2
TIEClock2
Command :MEASure:TIEClock2 <source>,{SECond |
UNITinterval},<direction>, {AUTO |
CUSTOM,<frequency> |
VARiable,<frequency>,<bandwidth> | CLOCk}
The :MEASure:TIEClock2 command measures time interval error on a clock.
You can set the units of the measurement by selecting SECond (seconds) or
UNITinterval. If AUTO is selected, the oscilloscope selects the ideal constant
clock frequency. If CUSTom is selected, you can enter your own ideal clock
frequency. If VARiable is selected, a first order PLL clock recovery is used at
the give clock frequency and loop bandwidth. If CLOCk is given, clock recovery
is specified with the :MEASure:CLOCk:METHod command is used.
<source>
{CHANnel<N> | FUNCtion<N> | WMEMory<N>}
<N>
is an integer, 1 - 4.
<direction>
{RISing | FALLing | BOTH}
Specifies direction of clock edge. BOTH selects the first edge from the left-hand
side of the waveform viewing area.
<frequency>
A real number for the ideal clock frequency for the clock time interval error.
<bandwidth> A real number for the loop bandwidth of the PLL clock recovery method.
Example This example measures the clock time interval error on the rising edge of
channel 1, ideal clock frequency set to automatic, units set to seconds.
10 OUTPUT 707;":MEASURE:TIECLOCK2 CHANNEL1,SECOND,RISING,AUTO"
20 END
This command is only available when the E2681A Jitter Analysis Software is installed.