Agilent Technologies E8247C, User Manual

Page: 53 / 220

Chapter 2 43
Basic Operation
Configuring the RF Output
3. Press
Sweep Time
to Manual >
5
>
sec
.
In auto mode, the sweep time automatically sets to the fastest allowable value. In manual mode, you can
select any sweep time slower than the fastest allowable. The fastest allowable sweep time is dependent
on the number of trace points and channels being used on the 8757D and the frequency span.
4. Press
Sweep Time
to Auto.
The sweep time returns to its fastest allowable setting.
Using Alternate Sweep
1. Press the
Save
hardkey.
This opens the table editor and softkey menu for saving instrument states. Notice that the
Select Reg
softkey is active. (For more information on saving instrument states refer to “Using the Instrument State
Register” on page 54 .)
2. Turn the front panel knob until you find an available register and press
SAVE
. Remember this saved
register number. If no registers are available, you can write over an in-use register, by pressing
Re-SAVE
.
NOTE
When you are using the PSG in a system with an 8757 network analyzer, you are limited to
using registers 1 through 9 in sequence 0 for saving and recalling states.
3. Press
Sweep/List
>
Configure Ramp/Step Sweep
and enter new start and stop frequency values for the ramp
sweep.
4. Press
Alternate Sweep Register
and turn the front panel knob to select the register number of the
previously saved sweep state.
5. Press
Alternate Sweep Off On
to On.
The signal generator alternates between the original saved sweep and the current sweep. You may need
to adjust 8757D settings to effectively view both sweeps, such as setting channel 2 to measure sensor A.
Refer to
Figure 2-6 .