22
Chapter 2
Controlling the Test Set and Making Measurements
Introduction
Introduction
The 87075C Option H08 is a slave instrument: a controller must be
used to control the test set. There are three ways in which the test set
can be controlled:
•
The controller can talk to the network analyzer using GPIB which
then controls the test set via the parallel connection.
•
The controller can control the test set using GPIB commands via the
GPIB connector.
•
A network analyzer equipped with a parallel connection can control
the test set directly.
The next three sections discuss the three methods of control.
Summary of Contents for 87075C Option H08
