Agilent Technologies 4338B, Operation Manual

Page: 144 / 228

SENSe Subsystem 4338B
Query response is <numeric value>, <NR2> format.
[:SENSe]:FIMP edance:CONT act:VERify fON j OFF j 1j 0 g
Sets or queries if the contact check function is enabled. The contact check function monitors if
the DUT is properly connected to the test electrodes .
ON , 1 enables contact check.
OFF , 0 disables contact check.
Query response is {1|0} .
Default setting is OFF .
[:SENSe]:FIMP edance:RANGe:A UTO f ON j OFF j 1 j 0 g
Sets or queries if the A uto range mode is enabled. In this mode the 4338B automatically selects
the optimum measurement range .
ON , 1 The A uto mode is ON
OFF , 0 The A uto mode OFF and the measurement range is in the Hold mode .
Query response is f 1 j 0 g .
[:SENSe]:FIMP edance:RANGe[:UPP er]
<numeric value>[MOHM j OHM j K OHM]
Sets or queries the measurement range . A vailable measurement ranges are 1 m, 10 m ,
100 m , 1 , 10 , 100 , 1 k, and 10 k, which are limited by the test level setting. (See
Figure 3-2)
<numeric value> is ,
numeric 1.0210
-3
, 1.0210
-2
, 1.0210
-1
, 1.0, 1.0210, 1.0210
2
, 1.0210
3
, 1.0210
4
( )
MAXimum 10 k
MINimum 1 m
UP move to upper range
DOWN move to lower range
F ollowing suxes can be used with <numeric value>.
MOHM : m OHM : KOHM :k
[:SENSe]:FUNCtion <sensor function >
Sets the measurement function to impedance measurement. The 4338B measures the vector
impedance of the DUT and then uses the vector impedance to calculate the other measurement
parameters . Y ou can select the measurement parameter using CALCulate{1|2}:FORMat
command.
sensor function measurement function
"FIMPedance" impedance
[:SENSe]:FUNCtion is always set to "FIMPedance" , which is only <sensor function> of the
4338B .
Query response is "FIMP" .
5-24 GPIB Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com