Agilent Technologies 1200 series, Reference Manual, Page: 160 / 278

160 Agilent 1200 Series Autosampler Reference Manual
4 Repairing the Autosampler
Changing the Product Number or Serial Number
When the main board has to be replaced, the new board does not have a serial
number. For some modules (e.g. pumps or autosamplers), the type has to be
changed (multiple usage boards). Use the information from the serial number
plate of your module.
The changes become active after the reboot of the module.
Using the Agilent ChemStation
Module serial numbers are entered by typing specific commands on the
command line at the bottom of the main user interface screen.
1 To enter a module serial number, type the following command into the
command line:
print sendmodule$(lals, "ser ‘YYYYYYYYYY’")
Where: YYYYYYYYYY is the 10-character serial number of the module in
question.
The reply line will respond with RA 0000 SER followed by the module serial
number you just entered.
To change the type of the module use the following command:
print sendmodule$(lals, "TYPE XXXXX")
When required If main board has been replaced.
Tools required User interface
Parts required none
Preparations • Turn the module on.
• Start the user interface.
N O T E
The first two characters are letters, which should be capitalized.