AGFA ANAPURNA MV, Technical Manual

Page: 88 / 215

88
SELECT SWITCH
SELECT SWITCH
-
-
1
1
1. Lamp Control<Left, Right>
1)MODE: OFF, LO, HI 3
OFF: In the OFF position, can not turn Lamp on.
LO : In the LO position, Lamp work as LO.
HI : In the HI position, Lamp work as HI.
※
If there is no signal from UV LAMP
even if Lamp select switch position in HI or LO, the LAMP won’t be on.
2) If pressing down F2>UV LAMP/SHUTTER in the MENU of OFF-LINE,
== UV LAMP/SHUTTER ==
UV LAMP:MODE = ON OFF TIME (Min)=20
SHUTTER: MODE = NORMAL DELAY (ON/OFF=) 30/30
LAMP USE HOUR:LEFT= 9.4 RIGHT= 28.7
Here, if UV LAMPMODE= ON, when doing all the prints including Prime and
Calibration, print with Lamp on.
If OFF, then when printing out all the prints including Prime or Calibration, print
with Lamp OFF.
The meaning of OFF-TIME (MIN)=30 is that UV LAMP will be OFF if next printing order
is not entered within 30 min after finishing print.
SHUTTER MODE = NORMAL - Operation of Normal shutter (Operation of right shutter.)
BOTH - two shutters will be operated at the same time. (right, left)
ex) In BI-DIRECTION printing
NORMAL : When printing out from HOME to PURGE, the right shutter will be opened,
When printing out from PURGE to HOME, the left shutter will be closed.
BOTH : When printing out from HOME(right) to PURGE(left), two opened and closed at the same
time. Again when printing out from PURGE(left) to HOME(right), two closed and opened at the same
time.
In accordance with type and thickness of media the mode will be selected by adjusting amount of
Light. LO will be selected for thin Acryl or film (soft material type)
HI is selected for glass or tile.
1
1 4 2 3