AGFA ANAPURNA MV, Technical Manual

Page: 91 / 215

91
ENCORDER CHECKING
ENCORDER CHECKING
1. Press CALIB button.
2. Press Key of F2> CARRIAGE SELEASE.
3. Move the carriage slowly to the right or the left by hand.
4. Check the ON/OFF of ENC A, ENC B LED for HEAD PCB.
5. Whenever finishing the encoder checking, press down the key of
F1> SERVO ON And HOME CHECK
6. If the servo is ON again, the carriage moves to the HOME
and then the HOME is checked.
7. PRIME TEST.
8. Check normal status while printing out.
9. Keep the cleanness of CODE STRIP. (wipe out with clean close)
*List of Notice
When you clean, never try to use solution, solvent, thinner, acetone,
other chemicals, the scale on the code strip can be erased.