Afag SREH-50-IOL, Assembly And Operating Instructions Manual

Page: 22 / 52

Installation, assembly and setting
22 – 52 Assembly instructions EN

SREH-50-IOL

Date 17.06.2022

Version 1.0
6 Installation, assembly and setting
The SREH-50-IOL module is an incomplete machine. For safe operation, the
module must be integrated into the safety concept of the system in which it is
installed.
During normal operation, it must be ensured that the user cannot interfere with
the working area of the smart rotary module. This can be achieved through
suitable protective measures (e.g., enclosure, light grid).
When the system is running in special operating modes, it must be ensured that
there is no danger to the operator.
The system operator is responsible for the installation of the SREH-50-IOL in
a system!
6.1 Safety instructions for installation and assembly
CAUTION
Personal injury caused by hot surfaces!
High surface temperatures of more than 60 °C can occur on the modules.
There is a risk of injury and damage to property.

Do not touch the housing or wear protective gloves!

No temperature-sensitive parts must be in contact or fastened!

Before touching hot surfaces without protective gloves, make sure they
have cooled down to ambient temperature.
CAUTION
Risk of injuries due to uncontrolled parts movements!
When connecting to the control system and during operation of the smart
rotary modules, unpredictable movements may occur and cause
injury/property damage.

Before working on the module SREH-50-IOL, make sure that the motor
supply is switched off and secured against unintentional restarting
 Chapter 6.3.1
CAUTION
Danger due to inadequate fastening!
The use of unsuitable fasteners and incorrect torques will result in the module
not being held in position by the fastener and may result injury and/or property
damage.

Only use the screws and centring sleeves intended for the SREH-50-IOL
with the appropriate torques!

The module may only be attached by trained personnel.