TECHNOPLAT CS/CW
TECHNOPLAT CS/CW TP
3.5. PNEUMATIC DEVICE
DESCRIPTION
The figure shows the positioning of the
devices on board of the machine.
1)
Tap.
to eliminate pneumatic pressure inside
the machine.
2)
Pressure regulator with filter and
pressure gauge.
to adjust general pressure of the
pneumatic plant.
Turn knob to change the pressure values
indicated on the pressure gauge.
3)
Pressure regulator with pressure
gauge.
To adjust the pressure of the
rubber/welder circuit.
|
Important
For further details see the pneumatic
diagram.
3.6. DESCRIPTION OF ACCESSORIES ON REQUEST
To enhance the performance and to increase the versatility of the machine, the manufacturer furnishes the
accessories listed below.
‒
Pneumatic pressure platen
(A)
:
pneumatically controlled device to
stabilise the load. It is equipped with a
rod pneumatic cylinder (MAX
800 mm
stroke).
It is necessary to adjust the height
depending on the dimensions of the
product to be wrapped.
For its operation, it is necessary to have
an air distribution system.
‒
Mechanical pressure platen
(D)
:
electrically controlled device to stabilise
the load, it is not necessary to adjust the
height depending on the dimensions of
the product to be wrapped.
‒
Platform loading/unloadingramp
(B)
: to
facilitate these operationsusing forklift
devices (pallet jack).
‒
Template for embedding: profiled structure for embedding the base in the ground.
‒
Sliding guide mast
(2400 - 2800 - 3100 mm)
: to wrap taller than standard loads.
25/79
