TECHNOPLAT CS/CW
TECHNOPLAT CS/CW TP
6.17.1.1.CYCLE WITH CUTTING DISABLED
At the end of the wrapping cycle the film is not automatically cut.
The gripper is not enabled.
6.17.1.2.CYCLE WITH SEALING DISABLED (CW VERSION ONLY)
At the end of the wrapping cycle the film is cut but it is not heat-sealed.
6.17.2. WRAPPING CYCLE WITH
FEEDER
To select this cycle, press button
(C3)
.
The machine performs a cycle which is
aimed at facilitating the coverage of the
pallet by the operator, and which
guarantees the highest degree of
protection possible.
The reel carriage rises to the top of the
load and then lowers by about
300 mm
stopping in this position.
If the machine is fitted with a top
pressure platen, this lifts from the load.
At this point, the operator, after having positioned the covering sheet on the top of the pallet, reactivates the
cycle by pressing the "Start" button; the presser descends once more.
The carriage rises again until it reaches the top of the pallet, performs the set number of upper wrappings of
the pallet, then descends once more, thus completing the cycle.
In this way, the position of the covering sheet, bound as it is by the upwards and downwards spirals of film,
guarantees excellent protection of the load against atmospheric agents (water, dust, etc).
6.18. STARTING AND
STOPPING THE CYCLE
Proceed as indicated.
1.
Place the load on turntable and set aside
the loading device.
2.
Fix the film to the limit stop (never to the
gripper).
3.
Press the "Cycle start" push-button
(A)
.
The machine performs a cycle and stops
automatically.
4.
Proceed to film cutting (if necessary).
5.
Remove the load and place another one
on the table to start a new cycle.
|
Important
To pause the cycle, press the "Stop cycle"
(B)
button.
Press the "start cycle" button
(A)
to restart.
62/79