17
4. Align the control horns over the factory drilled
holes.
Note:
Control horns have been set at a slight
offset to allow for maximum torque at full
deflection
6. Align the left and right sides of the control horns
to the mounting holes and secure using six wood
screws as shown.
5. Use thick CA on each screw prior to
installing to lock screws in place
Note:
CA glues have a fast drying time.
Remember to work quickly
3. Correct installation of ball link, flat washer and
brass spacer to servo arm shown below.
Note:
Flat washer prevents ball link from
coming off brass ball.
