16
13.
Repeat mounting steps for other servo so that
aileron servos are mounted in bottom of wing
as shown.
Note:
Servo output shaft should face towards the
wing leading edge. Servo arms should point
towards the wing tip.
12.
Install servo with servo mounting screws.
2.
Assemble two pushrod and control horn
assemblies as shown. The ball link goes
between the left and right sides of the control horn
sides and is secured with a nylon lock nut.
IMPORTANT
: The ball link for the root end
control horn goes in the bottom hole of the horn.
The ball link for the tip end horn goes in the mid-
dle hole of the horn. This gives the correct offset
to eliminate binding and twisting of the aileron.
Note:
It will still be necessary to either program or
use a after market type
Match Box
system to as-
sure your servos will not bind or fight against
each other.
Improperly installed servo linkages can cause ser-
vos to strip and ailerons to flutter. Aileron flutter
can and will destroy your model instantly!
Tip end
Middle hole
Root end
Bottom hole
Aileron Control Linkage Installation
1. Gather the aileron control linkage parts as shown
below. There are (2) 4-40 pushrods, (4) 4-40 ball
link assemblies, (2) Flat washers
(2) brass spacers,
(2) left and (2) right side control horns, (1) Adjust-
ment wrench (4) carbon reinforcement sleeves and
(12) wood screws for each wing panel.
