Aerotech XC2e, Hardware Manual, Page: 30 / 92

2.2. Motor Power Output Connector
DANGER : Before you do maintenance to the equipment, disconnect the electrical power.
Wait at least one (1) minute after removing the power supply before doing maintenance or
an inspection. Otherwise, there is the danger of electric shock.
The XC2e can be used to drive the following motor types:
l
Brushless (refer to Section 2.2.1. )
l
DC Brush (refer to Section 2.2.2. )
l
Stepper (refer to Section 2.2.3. )
For a complete list of electrical specifications, refer to Section 1.1.
The 7-pin terminal block style motor output connector is located on the front panel. The pinout for this
connector is shown in
Table 2-5 .
Table 2-5: Motor Power Output Connector Pinout
Pin Description
Recommended
Wire Size Connector
Earth Ground to Motor
0.5 mm
2
(#20 AWG)
A
Brushless Phase A Motor Lead
DC Brush +
Stepper
0.5 mm
2
(#20 AWG)
B
Brushless Phase B Motor Lead
Stepper
0.5 mm
2
(#20 AWG)
C
Brushless Phase C Motor Lead
DC Brush -
Stepper Return
0.5 mm
2
(#20 AWG)
Table 2-6: Mating Connector Part Numbers for the Motor Power Output Connector
Type
Aerotech
P/N
Third Party
P/N
Screw
Torque: Nm
Wire Size:
mm
2
[AWG]
7-Pin Terminal Block ECK02457 Phoenix 1839678 0.22 - 0.25 2.5 - 0.05 [14-30]
2.2. Motor Power Output Connector XC2e Hardware Manual
30 www.aerotech.com