Aerotech Soloist MP 10, Hardware Manual

Page: 84 / 94

Soloist MP Maintenance
5.1. Control Board
Figure 5-1: Control Board Assembly
Table 5-1: Control Board Fuse Information
Fuse Description Size Aerotech P/N Manufacturer's P/N
F1 Control Power at TB103-1 2 A F.B. EIF00136 Littelfuse 251002
F2 Bus Power at TB102-1
5 A S.B.
(5 mm)
EIF01026 Littelfuse 3721500041
Note: F1 is soldered to the circuit board.
Table 5-2: LED Description
LED Description
ENB/FLT
Turns green to indicate that the axis is enabled. Turns red to indicate a fault condition. The
ENB/FLT LED will flash between RED and GREEN if the drive is enabled and in a fault
condition.
MARKER Turns green to indicate that the marker input is high.
CTL* Turns green when power is applied.
POS Turns green to indicate that the axis is in position.
* If the power light flashes continuously and the unit does not operate, there is too much current draw from the 5V power supply or
the control supply voltage level is low.
84 Chapter 5 www.aerotech.com