Aerotech Soloist MP 10, Hardware Manual

Page: 20 / 94

20 Chapter 1 www.aerotech.com
1.2. Electrical Specifications
Table 1-6: Electrical Specifications
MP 10
Motor Supply
Input Voltage 10-80 VDC
Input Current
(Continuous)
5 A
rms
Input Current Refer to Section 1.2.1. System Power Requirements
Control Supply
Input Voltage 24-80 VDC (±10%)
Input Current 1 A max
Output Voltage
(1)
10-80 VDC
Peak Output Current (1 second) 10 A
Continuous Output Current 5 A
Power Amplifier Bandwidth 2500 Hz maximum (software selectable)
Power Amplifier Efficiency
85% - 95%
(2)
PWM Switching Frequency 20 kHz
Minimum Load Inductance 0.1 mH @ 80 VDC
User Power Supply Output 5 VDC (@ 500 milliamps)
Modes of Operation Brushless; Brush; Stepper
Protective Features
Output short circuit; Peak over current, DC bus over
voltages; RMS over current; Over temperature; Control
power supply under voltage; Power stage bias supply under
voltage
Isolation
Optical and transformer isolation between control and power
stages.
1. AC input voltage and load dependent.
2. Dependent on total output power: efficiency increases with increasing output power.
Soloist MP Introduction