Aerotech Soloist MP 10, Hardware Manual

Page: 48 / 94

48 Chapter 2 www.aerotech.com
2.3.2. Hall-Effect Interface (J103)
The Hall-effect switch inputs are recommended for AC brushless motor commutation but not absolutely
required. The Hall-effect inputs accept 5-24 VDC level signals. Hall states (0,0,0) or (1,1,1) are invalid and
will generate a "Hall Fault" axis fault.
Refer to Section 2.2.1.1. for Hall-effect device phasing.
Table 2-18: Hall-Effect Feedback Interface Pins on the Motor Feedback Connector (J103))
Pin# Description In/Out/Bi
1 Chassis Frame Ground N/A
3 +5V Power for Encoder (500 mA max) Output
5 Hall-Effect Sensor B (brushless motors only) Input
10 Hall-Effect Sensor A (brushless motors only) Input
11 Hall-Effect Sensor C (brushless motors only) Input
21 Signal Common for Encoder N/A
Figure 2-20: Hall-Effect Inputs (J103)
Soloist MP Installation and Configuration