MAINTENANCE MANUAL
AMT 200S
SECTION: 5
MM - 200-25
4. Recommended Calibration Pressure
4.1
Main Gear Tires
Recommended pressure : 45 ± 1.5 psi
(3.2 ± 0.1 Kg/ cm
2
))
4.2
Tail Gear Tire
Recommended pressure : 36.2 ± 1,5 psi (2.5 ± 0,1kg/cm
2
)
5. Battery
The battery GILL G-35 has the following characteristics :
12 V / 35 AH
In case you need to recharge the battery, clean the terminals first.
Do not let the current or the voltage reach more than 1,4 A and 12 V, respectively. Examine
electrolyte level frequently. Maintain the level between 0.15 in and 0.30 in above the positive and
negative plates. If the level is low, fill it with destilled water.
In case of electrical system malfunction, refer to the electrical system diagram on Section 1.
6. General Maintenance
6.1
Fatigue
Fatigue mainly happens on rods, levers, mounts, mufflers, brackets and exhaust tubes because
of high rates of vibration or high loads. Examine these parts carefully, specially their openings,
angles, welding points and joints. You can identify fatigue by means of visible cracks but you can
also use magnifying glass, penetrant or magnaflux. If you find a crack on a part not so important,
drill a stop hole of 0.06 or 0.09 inches (2 or 3 mm) of diameter. If you find a crack on an important
part, remove the part and replace it.
6.2
Erosion, Scratches and Nicks
Erosion starts on wing leading edges and propeller blades.
For propeller blades, refer to the Propeller Manual.
For wings and composite material parts, refer to Section 4.
Page 5.23
August 10, 2004 - Rev. 8
Summary of Contents for AMT 200S SUPER XIMANGO S
