MAINTENANCE MANUAL
AMT 200S
SECTION:1
MM - 200-25
7. Elevator Control System
7.1
Find below basic components of elevator control system.
1-
Control stick
2-
Rod n° 1
3-
Rod n° 2
4-
Rod n° 3
5-
Rod n° 4
6-
Bellcrank n° 1
7-
Bellcrank n° 2
8-
Bellcrank n° 3
9-
Bellcrank n° 4
10-
Elevator Assy
7.2
Rigging the elevator.
7.2.1 Remove the horizontal console inside cockpit
7.2.2 Make sure that the stop screws P/N TH-5x25-RT and TH-5x40-RT (ref. IPC fig.
15 itens 6 and 7) are not damaged. Replace them if necessary.
7.2.3 Put the elevator in neutral position and install the tool P/N 55400-A-28 F1 on the
horizontal stabilizer.
7.2.4 Install a protactor on the elevator and adjust it to zero degree.
7.2.5 Remove tool from the horizontal stabilizer and measure the travel on the elevator.
7.2.6 Adjust the up and down position as required by regulating the stop screws P/N TH-
5x25-RT and TH-5x40-RT referenced above. See elevator control surface travel on
section 3.
Page 1.24
August 10, 2004 - Rev. 8
Summary of Contents for AMT 200S SUPER XIMANGO S
