MAINTENANCE MANUAL
AMT 200S
SECTION:1
MM - 200-25
11.4
Landing Gear Control Lever Rigging - (See figure below)
11.4.1
Do the rigging procedure with the landing gear retracted.
(1)
Adjust the length of the control link rod (2) so it does not pass the upper dead
center as it is shown in the figure below, forming at maximum an angle of 175°
between the rod and the torque tube cranck.
(2)
Tighten the nut of the control link rod and lock it using a lock washer.
1-
Landing gear control lever
2-
Landing gear control link rod
3-
Landing gear torque tube
4-
Retracted landing gear micro switch
5-
Center console
Page 1.38
August 10, 2004 - Rev. 8
Summary of Contents for AMT 200S SUPER XIMANGO S
