MAINTENANCE MANUAL
AMT 200S
SECTION:1
MM - 200-25
10. Airbrake Control System
10.1
Basic components
1-
Airbrake control lever
2-
Airbrake control link rod
3-
Airbrake angular transmission gear box
4-
Airbrake push rod
5-
Airbrake torque tube (rod)
6-
Airbrake housing
10.2
Rigging
(1)
Extended:
Inspect the correct airbrake extension by adjusting the stop screw
at the base of the control lever below the center console.
(2)
Retracted:
Inspect the airbrake locking and its opening by adjusting the length
of the push rod (fig. 2 item 4) located in the airbrake. The airbrake
height must be the same for the two wings and the airbrakes must
open simultaneously
Measure the extended airbrakes near the wing root, from the upper wing surface to the
upper airbrake surface. The height must be 6.38 in ± 0.31 in (162 mm ± 8 mm)
(3)
Adjusting the Micro Switch (See figure 2)
1-
Keep airbrakes retracted and locked.
2-
Approach the micro switch to the airbrake control lever until activate micro
switch is depressed.
3-
Tighten the micro switch in this position.
Page 1.30
August 10, 2004 - Rev. 8
Summary of Contents for AMT 200S SUPER XIMANGO S
