Aeroflex 2050T SERIES, Operating Manual, Page: 143 / 322

ANALOG MODULATION MODE
3-94
Table 3-3 Foreground errors
Error Descriptive text Error Descriptive text
No. Type No. Type
46 exe Recall Checksum 51 exe Carrier Outside Limits
47 exe Incorrect Setup 52 exe RF Level Outside Limits
48 exe Invalid Memory Number 53 exe Mod Rate Outside Limits
49 exe MODULATION NOT ENABLED 54 exe LF Freq. Outside Limits
50 exe Out of Range 55 exe LF Level Outside Limits
56 exe AM Outside Limits 61 exe RF Level Step Too Big
57 exe FM Outside Limits 62 exe Mod Rate Step Too Big
58 exe PM Outside Limits 63 exe LF Freq. Step Too Big
59 exe WBFM Outside Limits 64 exe LF Level Step Too Big
60 exe Carrier Step Too Big 65 exe AM Step Too Big
66 exe FM Step Too Big 71 exe Sweep Stop Out of Range
67 exe PM Step Too Big 72 exe Sweep Steps Out of Range
68 exe Invalid Latch Number 73 exe Sweep Time Out of Range
69 exe Invalid Latch Data 74 exe Sweep Marker Out of Range
70 exe Sweep Start Out of Range 75 exe Attenuator EAROM Read
76 exe Attenuator EAROM Write 81 exe EAROM Wrap Around Error
77 exe RF Option Box EAROM Read 82 exe Continuous Tone Checksum
78 exe RF Option Box EAROM Write 83 exe Sequential Tone Checksum
79 exe EAROM Write Error 84 exe Tone data Out of Range
80 exe EAROM Read Error 85 exe Tone Offset Out of Range
86 exe Clock Data Entry Error 91 exe RF levelling fault
87 exe At Top Limit 92 exe REPEAT THIS CALIBRATION
88 exe At Bottom Limit 93 exe DSP Not Responding
89 exe Ext. Trigger Disabled 94 exe A/D Conversion Failure
90 dde Int. Std. Not Selected 95 exe Tone Sequence Incorrect
96 exe Mod. Autocal Failure
97 - -
98 exe Direct Doppler Limited
99 exe Insufficient Points
100 exe Carrier Outside Profile