TM-05
TM-07
TM-02
TM-08
TM-04
TM-05
TM-02
TM-19
TM-07
TM-18
Fit ribs TM-08 to TM-17 in place. Make sure you position ribs exactly at right angles in relation to spar, then glue in place. Note, that ribs are
glued to spruce spar, main spar and trailing edge sheeting. Do not apply glue to front part of ribs between wing spar and leading edge
position.
4
Note:
Root rib TM-07 will be fitted at a later stage
together with TM-05. TM-05 determines the correct dihedral
angle for the root rib.
Glue in place TM-04 and TM-05 together with top spar
TM-02 (spruce, 3 x 8 mm). Glue in place root rib TM-07
and make sure it is slightly angled in accordance with
dihedral of wing.
5
Glue supports TM-18 into ribs at the spoiler position and
glue sheeting panel TM-19 in place.
6
Note that sheeting is centred on
supports and ribs which act as an end
stop for the spoiler.
TM-17
th
Insert servo tray TM-20 between ribs in 4 rib bay and glue flush with
underside of ribs and to wing spar.
Insert wing joiner R-40 into sleeve TM-21 and make sure it moves freely
and without binding. Carefully sand surface of wing joiner sleeve TM-21
and insert in wing root. Glue with epoxy mixed with glass fibres.
Align magnet supports TM-31 and TM-32 with corresponding
holes in root rib TM-07, then glue to the inside of root
rib.
Remove wing from jig. Slightly bevel the last 3 mm of trailing edge
sheeting to establish a good contact surface for gluing. Then glue in
place top sheeting TM-06. Glue together wing root sheeting material
TM-122 and TM-23, then glue to outer rib bays.
Tip:
Glue rear edge of sheeting with epoxy to get a strong trailing
edge which can be sanded down to fine profile.
Glue bottom sheeting material
to ribs. For best results use thin
CA.
TM-20
TM-21
TM-22
TM-22
TM-23
TM-23
TM-06
TM-31
TM-32
7
8
9
30
31
