Glue false leading edge TS-36 (balsa, 2 x 8 mm) to ribs and
bottom sheeting. Sand flush with top of ribs after glue has
dried.
Glue in place top sheeting TS-01 on ribs, spar and flase leading edge. Use suitable weights and tape to secure
sheeting material until glue has dried completely.
Cut off sheeting material flush with false leading edge then carefully sand sheeting
material flush with false leading edge. Use a long sanding bar for best results. Then
glue leading edge TS-37 (balsa, 3 x 8 mm) to false leading eding edge and sand to
shape after glue has dried.
14
15
16
TS-36
TS-01
TS-37
Make up wing tips from 3 parts TS-38 and
secure with clamps until dry.
Sand sheeting material and spars flush
with tip rib TS-25 and glue in place wing
tip TS-38.
Then sand wing tip to fit planform of wing
and shape of wing section.
17
18
TS-38
TS-38
Remove wing from building board. Please handle with care and
always place on an even surface, as the wing has no tortional stability
at this time.
Glue bottom sheeting material to ribs. For best results use thin CA.
Also glue in place sheeting material to the underside of wing
root.
13
16
17
