Assemble horizontal formers R-03.1 to R-03.3
with former R-04 S and formers R-05 to R-09 and
insert in notches in fuselage side. Do not glue!
Check position and alignment of formers. Then
remove, apply glue and glue to fuselage side and
each other.
Glue in place formers R-10, R-11 S and R-12 S.
Make sure fuselage sides are absolutely
symmetrical.
4 S
Turn the fuselage upside down and secure on building board with weights and
pins.
Glue reinforcements R-14 S, to which a high start hook can be attached, into
formers R-04 S, R-05 and R-06. First glue together reinforcements, then
glue assembly into formers.
6 S
R-04 S
R-10
R-11 S
R-12 S
R-14 S
Section II - Sailplane Version
Assemble and glue cabin from side panels R-20, formers R-21 and R-22 S as well
as 1.5 mm balsa sheeting R-29. For best results this is done directly in the cockpit
opening of the fuselage which is protected by cling film.
Note:
Magnet support R-23 and magnets are
glued in place after cabin has been thoroughly
sanded and fitted in place.
11 S
The nose of the sailplane consists of formers R-31 S to R-33 S. Assemble and glue
directly into front fuselage former.
14 S
Fill up the corners of the nose with parts R-34 S and R-35 S.
Sand fuselage and cabin and round off the edges with a radius of 5 to 10 mm.
Also round off fuselage nose for a streamlined shape.
15 S
R-20
R-21
R-22 S
R-31 S
R-32 S
R-33 S
R-34 S
R-35 S
2 S
Refer to section I for construction of the sailplane version
of the fuselage. Section II explains only those building
steps and parts that differ from the E version.
8
9
