Glue together wing root sheeting material TM-22 and
TM-23, then glue to first rib bay on either side of
wing.
Place wing on building board and glue false leading
edge TM-24 (balsa, 2 x 8 mm) to ribs and bottom
sheeting. Sand flush with top of ribs after glue has dried.
Glue in place top sheeting TM-01 on ribs, spar and
false leading edge. Use suitable weights and tape to
secure sheeting material until glue has dried
completely.
TM-22
TM-24
TM-01
TM-23
Sand sheeting material flush with false leading edge.
Use a long sanding bar for best results.
Glue leading edge TM-25 (balsa, 3 x 8 mm) to false
leading eding edge and sand to shape after glue has
dried.
Glue control horn TM-27 to spoiler TM-26. Make
sure to build a left and a right spoiler! File a notch
for control horn TM-27 and fit spoiler in place.
When wing is has been covered, attach spoiler to
wing with tape.
When covering is complete, glue inner wing panels and outer
wing panels together. Protect covering material next to contact
surfaces with tape.
Apply a liberal amount of epoxy to wing joiners and ribs. Insert
wing joiners in slots andpress wing panels together. Secure
with tape until glue has cured.
A final sanding will make the inner wing panel ready to cover. Wing joiner TM-28, wing locator dowel TM-29 and magnets TM-30 are
glued in place after finish is complete.
Make sure that inner wing panels and outer wing panels fit together well. Root ribs should fit together without a gap. Correct, if
necessary, to achieve a perfect fit.
Note for Triple thermic:
Route aileron servo leads through ribs of inner wing panel before inner wing panel is covered!
TM-25
TM-26
TM-27
10
11
12
13
14
15
32
33
