8
9
10
Cut to length upper spruce spar TS-02 (2 x 8 mm) and glue to ribs and main spar. Use suitable weigths to hold spar in place and leave to dry.
Glue in place aileron spar TS-28, aileron leading edge TS-29 as well as gussets TS-30 and TS-31. Insert servo tray TS-32
between ribs TS-16 and TS-17 and glue flush with underside of ribs and to wing spar.
TS-02
TS-29
TS-28
TS-30
TS-31
TS-32
Slightly bevel the last 3 mm of trailing edge and aileron sheeting to establish a good contact surface for gluing. Then glue in place top sheeting.
Tip:
Glue rear edge of sheeting with epoxy to get a strong trailing edge which can be sanded down to fine profile.
Carefully sand surface of wing joiner sleeve TS-35 and insert in wing root. Insert wing joiner R-40 into sleeve and make sure it
moves freely and without binding. Then remove R-40 and glue sleeve in place with epoxy mixed with glass fibres.
Align magnet supports TS-46 and TS-47 with corresponding holes in rib TS-08, then glue to the inside of rib T-08.
11
TS-35
Glue together wing root sheeting material TS-33
and TS-34, then glue to first two rib bays.
12
TS-33
TS-34
TS-46
TS-47
14
15
