Aeon 350cc, Service Manual

Page: 91 / 192

ENGINE
4-91
STATOR HOUSING INSTALLATION
NOTE: The stator, flywheel, starter drive, and stator
can be serviced with the engine in the frame.
1. Apply a light amount of Crankcase Sealant to the mounting
surface and install a new gasket. Install the dowel pins.
SPARK PLUG FOULING
TROUBLESHOOTING
◎ Spark plug cap loose or faulty
◎
Choke cable adjustment or plunger/cable sticking
◎
Foreign material on choke plunger seat or plunger
◎
Incorrect spark plug heat range or gap
◎
Carburetor inlet needle and seat worn
◎ Jet needle and/or needle jet worn or improperly adjusted
◎
Excessive carburetor vibration (loose or missing needle jet
locating pins)
◎
Loose jets in carburetor or calibration incorrect for
altitude/temperature
◎ Incorrect float level setting
◎
CVT system calibrated incorrectly or components worn or
miss-adjusted
◎
Fuel quality poor (old) or octane too high
◎
Low compression
◎ Restricted exhaust
◎
Weak ignition (loose coil ground, faulty coil, or stator,)
◎
Restricted air filter (main or pre-cleaner) or breather
system
◎
Improperly assembled air intake system
◎ Restricted engine breather system
◎
Oil contaminated with fuel
◎
Restricted crankcase vent
2. Seal stator wire grommet with Crankcase Sealant.
3. Install the housing. Torque bolts in sequence to
specification.
Stator Cover Bolt Torque:
8 Nm (6 ft. lbs.)