Clamp-on Ground Resistance Tester Model 6417
47
9.5 Safety
The instrument complies with IEC 61010-1, and IEC 61010-2-032 for the
following:
■
Measurement inputs and enclosure: 600V CAT IV
5003266
Conforms to UL Std. UL 61010-1
Conforms to UL Std. UL 61010-2-032
Cert. to CAN/CSA Std. C22.2 No. 61010-1
Cert. to CSA Std. C22.2#61010-2-032
Insulation class:
2
Pollution degree:
2
Overvoltage category:
600V CAT IV
■
Emissions and immunity in an industrial setting compliant with IEC
61326-1
Specifications are subject to change without notice.
10. MAINTENANCE
Use only factory specified replacement parts. AEMC
®
will not be held responsible
for any accident, incident, or malfunction following a repair done other than by its
service center or by an approved repair center.
10.1 Cleaning
Disconnect anything connected to the device and set the switch to OFF
■
Use a soft cloth lightly moistened with soapy water, taking care not to touch
the contacts inside the clamp. Wipe with a moist cloth and then completely
dry with a dry cloth.
■
Never use alcohol, solvents or hydrocarbons.
10.2 Battery Replacement
The Model 6417 is powered by four 1.5V batteries. The battery replacement
indicator will blink when battery voltage is low and will display continuously when
battery replacement is required.
■
The instrument must be OFF and disconnected from any conductor.
■
Place the meter face down and remove the two Phillips screws on the back of
the instrument.
■
Remove back cover from the instrument.
■
Remove the used batteries and replace with four new batteries (LR6, AA,
1.5V), observing the polarities.
■
Replace the back cover and secure into position by tightening the screws.
Used batteries must not be treated as ordinary household waste. Recycle them
appropriately.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
