Advantech MIC-6314 Series, User Manual

Page: 74 / 136

MIC-6314 User Manual 62
3.5.3.1 LAN Controller Channel Selection and Priority
In addition to the selected LAN controller interface, users may need to configure
every LAN controller channel (port) as a dedicated NC-SI interface to the BMC. Addi-
tional OEM commands for configuring the NC-SI LAN controller channel selection
and priority are provided to ensure flexible configuration.
LAN channel selection priority setting list:
0 = The first channel that to be linked gets the NC-SI connection to the BMC.
1 = Channel 1 is the preferred port if available, otherwise use channel 2 if available.
2 = Channel 2 is the preferred port if available, otherwise use channel 1 if available.
3 = Channel 1 is the only allowed port, always use it, never change to channel 2.
4 = Channel 2 is the only allowed port, always use it, never change to channel 1.
The NC-SI LAN controller channel setting is stored permanently (non-volatile
EEPROM). The default value is 0.
Read LAN channel selection priority:
Response:
Change LAN channel selection priority:
Response:
3.5.4 FPGA COM Port UART MUX
MIC-6314 features several serial interfaces that can be flexibly configured by imple-
menting an UART MUX (refer to Section 3.6 – UART and UART Multiplexer). The
BMC provides OEM commands for configuring UARTs via IPMI. The available COM1
and COM2 port settings are shown below (Advantech recommends that you verify
the UART dependency.).
COM interfaces:
ipmitool raw 0x2e 0x41 0x39 0x28 0x00 0x04 0x01
39 28 00 <setting>
ipmitool raw 0x2e 0x40 0x39 0x28 0x00 0x04 0x01 <setting>
39 28 00
Table 3.11: OEM Interfaces
Port Interface
0x00 COM1
0x01 COM2
0x02 BMC UART