Advantech MIC-6314 Series, User Manual

Page: 73 / 136

61 MIC-6314 User Manual
Chapter 3
B
MC Firmware
O
peration
3.5.1 IPMItool Raw Command
To use Advantech OEM commands with the open source IPMItool, users must
employ the “raw” command of IPMItool. The structure of the IPMItool raw command
is detailed below.
General raw request:
Response, if raw <netfn> is 2Eh (OEM/Group):
3.5.2 Configuration OEM Commands
The Read and Store Configuration OEM commands can be used to read and change
several important board settings. The required command details are described in the
following sections.
3.5.3 LAN Controller Interface Selection
The BMC firmware provides OEM IPMI commands to allow users to switch the one
BMC connected NC-SI interface between four I350 LAN channels. This command
can be used to read the selected IPMI-over-LAN interface and change the selection.
LAN controller interface selection settings:
00h: Group 0, I350 Port 2 and Port 3 (BMC default)
01h: Group 1, I350 Port 0 and Port 1
Read LAN interface selection:
Response:
Change LAN interface selection:
Response:
ipmitool raw <netfn> <cmd> [data]
<IANA Enterprise Number> [data]
ipmitool raw 0x2e 0x41 0x39 0x28 0x00 0x04 0x00
39 28 00 <setting>
ipmitool raw 0x2e 0x40 0x39 0x28 0x00 0x04 0x00 <setting>
39 28 00