Attaching the cable cover
DLT-V83 Operating Instructions V2.00
131 / 157
15.3.
Attaching cable grommets and fixing strain relief in place
Important preparatory work
1. Checking the cable diameters and elasticity.
Check the cable diameters and elasticity of all the cables to be connected.
A cable grommet suitable for the diameter and elasticity of the cable must be used.
Bear the following points in mind when selecting a cable grommet:
- The grommet must completely surround the cable.
- The opening of the grommet must be slightly smaller than the cable diameter.
NOTICE
: If a grommet is used that is too large or too small, the device will not be properly sealed.
2. Preparing the required cable grommets and dummy grommets.
Remove the required cable grommets and dummy grommets from the cable sealing set (using
scissors, for example).
Cut the grommets off as cleanly as possible at the separation point so that they fit into the cable
openings and seal them tightly.
Cable grommets and dummy grommets should be cut off as cleanly as possible. This is important in
order to seal the Industrial Computer well.
Correct:
Incorrect:
Figure 3: Cable grommets and dummy grommets
