a d v a n c e d i l l u m i n a t i o n . c o m
P u l s a r 3 2 0 M a n u a l
P u l s a r 3 2 0 M a n u a l
SELECT DEVICE:
- Connects to target Pulsar-320 (USB)
START LOADER:
- Allows firmware to be flashed to memory: internal use only
- Provides access to ‘Manufacturing Data’:
DIP switch ‘S1’ must have position
6 ENABLED in order to program
manufacturing data
START APPLICATION:
- Resets the H8 and refreshes the USB connection
RUN DIAGNOSTICS:
- Performs a low-level diagnostic test:
Internal use only
APPLICATON:
- Loader for firmware:
Internal use only
MANUFACTURING DATA:
- Serial Number:
Factory Set
- MAC Address*:
Factory Set
*MAC Addresses are provided by the IEEE. Any adjustments to this address may cause
conflicts with other equipment not related to this product. Advanced illumination as
-
sumes NO responsibility for conflicts caused by this parameter being changed from its
factory setting*
- Default IP:
Factory Set 192.168.24.240
- 48V limit:
Limits output voltage from the
pulsar to 48V
CONFIGURATON DATA:
- Initial LED Temp*:
Factory Set
*This parameter contains information that could be harmful to the attached light head if
altered. Advanced Illumination assumes NO responsibility for damaged products if this
parameter is changed from factory settings without prior approval*
- Supply Overhead:
Factory Set
- Operating Mode/Trigger/Pulse:
Low-level user interface
- Slew Rate:
Adjusts the On-time response of
the pulse. Use to compensate for
high EMI situations
- Differential (Trig1 & Trig2):
Check to enable differential triggers
- Program Config. Data:
stores all changes to this section into
memory
37
