a d v a n c e d i l l u m i n a t i o n . c o m
P u l s a r 3 2 0 M a n u a l
P u l s a r 3 2 0 M a n u a l
28
Ethernet
(Electrical)
Ethernet
Not fully supported by
current software interface
(Mechanical)
8 position - 8 conductor RJ45 w/
metal shield
Link and Rx/Tx LEDs for
Ethernet
(Protocol)
TCP/IP, UDP, TFTP via 10/100Base-T
Other protocols TBD
Trigger
(Electrical)
2 Independent Trigger Inputs
(hardware)
1 Trigger may be
mapped to both
outputs
Differential (RS485 Receiver-AC
Termination)
0 - 30V
Timing Bypass Function
Light output follows
gated input pulse width
up to maximum output
pulse width allowed by
controller. Active high
or active low
Uses proprietary
Signatech II parameters
(continued next page)
(Specifications cont.)
Allows user to produce
a train of light pulses
from a single trigger
incident. Will allow up
to a maximum 16-bit
input value (64000
pulses). Users can adjust
hold time for timing
purposes.
Pulse repetition mode with hold
time
(Mechanical)
See model
(Protocol)
Trigger Width: >2 µS
Trigger Pulse Rise/Fall Time: <200nS
Leading or Trailing Edge
Selection
Input Power
(Electrical)
12-36 VDC (24V nominal @ 4A max)
(Mechanical)
2-pin - Mateable Terminal Block
(5.08mm Phoenix Terminal Block)
Polarity Protected, On-
Board Fuse Protected
(Replaceable) Power
is switched via a SPST
rocker switch
