Jumpers and Connectors
49
S1, S2: LAN2 Connecting Selection
Setting Jumper on cPCI-6810/6820
A 3-pin jumper (JP1) is used to set the SBC as either “in normal
operation” or “forcing the SBC to SYSTEM mode”.
LAN 2
Connecting
Switch S1
Switch S2
Pin
State
Pin
State
Connect to
PICMG 2.16
Backplane only
S1-1 OFF S2-1
OFF
S1-2 OFF S2-2
OFF
S1-3 OFF S2-3
OFF
S1-4 OFF S2-4
OFF
Connect to
Rear Panel
(Default)
S1-1
ON
S2-1
ON
S1-2
ON
S2-2
ON
S1-3
ON
S2-3
ON
S1-4
ON
S2-4
ON
Table 2-23: LAN2 Connecting Selection
Note:
When cPCI-6810/6820 in the Packet Switching
Backplane has no PCI bus, set JP1 as “1-2”.
Normal operation (Default setting)
Force cPCI-6810/6820 to SYSTEM mode
3
2
1
3
2
1
Summary of Contents for cPCI-6810
