Getting Started
51
3
Getting Started
This chapter provides information on how to install the necessary
components on the cPCI-6810/6820 and cPCI-R6820 RTM. The
topics covered are:
X
CPU and heat sink
X
Memory module installation
X
HDD installation on main board
X
HDD installation on RTM
X
CF installation on RTM
X
PMC installation
X
RTM installation
X
Main board installation
3.1 CPU and Heatsink
The cPCI-6810/6820 SBC supports the Intel® Pentium® III
Processor - Low Power up to 1033MHz, which is pre-mounted to
the PCB (printed circuit board). The heatsink has also been pre-
mounted in the factory. There is no jumper setting necessary to
set the CPU operating frequency or CPU type.
3.2 Memory Module Installation
The cPCI-6810/6820 SBC supports up to four sockets of 144-pin
PC-133 registered ECC SO-DIMMs. The maximum memory
capacity is therefore 2GB. If memory modules are pre-installed
when the package is received, this section can be skipped.
WARNING:
DO NOT try to replace the CPU in the field or remove
the heatsink. It will cause board defects and void all
warranty for the board.
Summary of Contents for cPCI-6810
