ADEMCO 7845CZ, Installation And Setup Manual

Page: 35 / 64

Section 5: 7845CZ Installation
5–9
Question 35.
Restore Zn4 Y/N)
Press [Y] to report restores on zone 4.
Press [N] to disable restoral reporting on zone 4.
Question 36.
Restore Zn5 Y/N)
Press [Y] to report restores on zone 5.
Press [N] to disable restoral reporting on zone 5.
Question 37.
Restore Zn6 Y/N)
Press [Y] to report restores on zone 6.
Press [N] to disable restoral reporting on zone 6.
NOTE: If Arm/Disarm feature is enabled, skip to Question 39.
Question 38.
Restore Zn7 Y/N)
Press [Y] to report restores on zone 7.
Press [N] to disable restoral reporting on zone 7.
Telco Channel and Open/Close Zone (Questions 39-40)
Question 39.
Telco Chan
(00)
Enter the physical telco line fault zone.
Zones 1 and 2 CANNOT be used.
If the Lynx Panic feature is enabled, Zone 3 cannot be used.
If the Arm/Disarm feature is enabled, Zone 7 cannot be
used.
A [0] entry disables telco detection.
Question 40.
Open Close Zone
(00)
Enter the open/close reporting zone number.
Zones 1 and 2 CANNOT be used.
If the Lynx Panic feature is enabled, Zone 3 cannot be used.
If the Arm/Disarm feature is enabled, Zone 7 cannot be
used.
A [0] entry disables open/close reporting.
If this zone selection is the same as the telco zone, the
displayed value will appear as “??”. The two entries must
be unique.
Redundant Central Station Reporting (Questions 41-53)
Question 41.
2nd CS (Y/N)
Press [Y] if redundant reporting to a second central station
is desired.
Press [N] if not desired (skip to end).
Question 42.
2CS Zone 1 (Y/N)
Press [Y] to enable reporting to second central station for
zone 1.
Press [N] to disable reporting.
Question 43.
2CS Zone 2 (Y/N)
Press [Y] to enable reporting to second central station for
zone 2.
Press [N] to disable reporting.
Question 44.
2CS Zone 3 (Y/N)
Press [Y] to enable reporting to second central station for
zone 3.
Press [N] to disable reporting.
Question 45.
2CS Zone 4 (Y/N)
Press [Y] to enable reporting to second central station for
zone 4.
Press [N] to disable reporting.