ADEMCO 7845CZ, Installation And Setup Manual

Page: 12 / 64

7845CZ Installation and Setup Guide
2–2
Table 1. 7720P Programming Tool Keyboard Commands
COMMAND FUNCTION
A Software revision
B Radio and connectivity display (network OK, no service, no contact, signal
strength, A or B carrier, MIN)
C Network time display
D Battery test (starts 10-minute battery test)
E Network system display (channel, local carrier, SID)
F Carrier display (A or B carrier, MicroBurst found, preferred side indication)
S Status display
T Test signal/Test registration when unregistered
X Reset
↑
Register radio (must be programmed)
↓
Replacement radio (must have PIN)
4. Program the Radio
•
Determine how the input zones will be used.
•
Connect the 7720P Programming Tool; reset the radio by cycling the power off, then on;
press [Enter] during the initial power-up sequence to enter Programming mode.
•
Program the 7845CZ as described in the Programming section.
5. Register the Radio
•
Send test registration with the 7720P [T] command to verify account and routing.
•
Register the 7845CZ with AlarmNet by triple-clicking the tamper switch and observing
the LED displays as shown below, or by pressing the [
↑
] key on the 7720P.
off blink rapid
blink
on
LED Key
6. Complete the Installation
•
Mount the radio (refer to “Mounting and Wiring”).
•
Wire to the control panel (refer to “Mounting and Wiring”) and test all signals.
•
Test the installation (refer to the “Testing the Installation” paragraph in Section 4).
"click"
"click"
"click"
R E G I S T R A T I O N
G
Y
R
registration
progress
Y
Y G G G
Y Y G G G
Y Y G G G
Y Y G G G
M S G 1
S E N T
M S G 2
S E N T
M S G 3
S E N T
W A I T
A C K