ADEMCO 7845CZ, Installation And Setup Manual

Page: 29 / 64

Section 5: 7845CZ Installation
5–3
Table 6. 7720P Normal and Shift Key (shift LED lit) Functions
KEY NORMAL KEY FUNCTION SHIFT KEY FUNCTION
BS/ESC [BS]: Press to delete entry [ESC]: Press to quit program mode; also can
reset EEPROM defaults*
↓
/
↑
[
↓
]: Scroll down programming [
↑
]: Scroll up programming
N/Y [N]: Press for “NO” answer [Y]: Press [SHIFT] [Y] for “YES” answer
SHIFT Press before pressing a Shift key function. Will light Shift LED. LED goes out once a
key is pressed. Press again for each Shift function desired.
1/A [1]: For entering the number 1 [A]: For entering letter A
2/B [2]: For entering the number 2 [B]: For entering letter B
3/C [3]: For entering the number 3 [C]: For entering letter C
4/D [4]: For entering the number 4 [D]: For entering letter D
5/E [5]: For entering the number 5 [E]: For entering letter E
6/F [6]: For entering the number 6 [F]: For entering letter F
7/S [7]: For entering the number 7 [S]: For entering letter S
8/T [8]: For entering the number 8 [T]: For entering letter T
9/X [9]: For entering the number 9 [X]: For entering letter X
SPACE [SPACE]: For scrolling option list No Shift function
0 [0]: For entering the number 0 No Shift function
#/ENTER [#/ENTER]: Press to accept entries No Shift function
* Active only when the “REVIEW?” prompt is displayed.
After connecting the 7720P cable, power up the 7845CZ. The following is displayed:
7845CZ x.xx
© Pittway 2001
x.xx = current software revision level
At this prompt during initial power-up, you may proceed with programming the 7845CZ.
Programming is accomplished by answering displayed questions. Most questions require
only a [Y]es or [N]o response, while others require a numerical response (ID numbers, etc.).
Press the [ENTER] key to accept each response and proceed to the next question. A “?”
displayed indicates an invalid entry. The current value is displayed on the second line in
parentheses ( ). To accept the current entry, press the [ENTER] key. If the current value is
an invalid entry, pressing the [ENTER] key causes the display to repeat the unanswered
question; the next question is not displayed until a valid answer is entered. Use the up/down
arrow keys to scroll through the programming questions without changing any values. Press
the [ESC] key to go to the end of the list of questions.
Enter programming mode by pressing [ENTER] during the initial power-up period after
the chaser sequence (while radio status LEDs are blinking consecutively or in unison).
The 7845CZ reads its EEROM to determine its preprogrammed parameters. A CRC of the
EEROM locations is also read. If the computed CRC does not match the one read from
EEROM, or if the programming parameters are invalid, the 7720P LCD displays “NO PROG”
and the radio status LEDs blink in unison (after the initial chaser sequence). Otherwise, the
LEDs blink consecutively.
Password Protection
The programming menu can be password-protected.
Once a password is assigned, the following prompt appears upon entering programming
mode:
ENTER PASSWORD: