ADC AD120i, Installation & Operator'S Manual, Page: 9 / 30

113546 - 2 www.adclaundry.com 9
FIGURE 3
FIGURE 1
FIGURE 2
Unpacking / Setting Up ________________
Remove protective shipping material (i.e., plastic wrap and
optional shipping box) from the dryer.
IMPORTANT: Dryer must be transported and handled in an
upright position at all times.
The dryer can be moved to its final location while still attached
to the skid or with the skid removed. To remove the skid from
the dryer, locate and remove the four lag bolts securing the
base of the dryer to the wooden skid. Two are located at the
rear corners (accessed by removing the lower back guard),
and the others at the front corners and are accessed by
opening the lint door.
Leveling Dryer
To level dryer, place
4-inch (10.2 cm) square
metal shims (refer to the
illustration below) or
other suitable material
under the base pads. For
optimal performance the
dryer should be level front
to back and side to side.
To Remove Top Console (Module)
1. Remove the outer top, top back guard, bottom back guard
and rear electrical box cover (refer to the Component
Identification drawing).
2. Remove (8) bolts, washers and lock washers -L- (figure
1) that secure the top console (module) to the dryer base.
3. Disconnect (2) plugs -B- and -C- (figure 2) in rear electrical
box.
4. Disconnect the sail switch wires -J- (figure 2) and pass
them up through hole -H- (figures 1 and 2).
5. Disconnect the ten pin connector -G- (figure 1 and 2).
Pass it and the 10 wires leading from it down through
hole -H- (figures 1 and 2).
6. If dryer is equipped with S.A.F.E. system, disconnect the
S.A.F.E. system probe and ground wires -D- (figure 2)
and four S.A.F.E. system valve wires -K- (figure 2) and
pass them up through hole -F- (figures 1 and 2).
7. On dryers with left side door hinges, disconnect door
switch door switch plug -A- (figure 3).
8. Lift the top console (module) off the dryer base. Use
lifting holes -E- (figure 2) as necessary.
To Install Top Console (Module)
Reverse steps 1 through 8 to install top console (module).
Flush sides of console with sides of dryer base (figure 3) prior
to tightening bolts in step 2.