ADC AD120i, Installation & Operator'S Manual, Page: 5 / 30

113546 - 2 www.adclaundry.com 5
!
!
NOTES _______________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
NOTES _______________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
Warning
To reduce the risk of personal injury, install
lockable doors to prevent public access to the rear
of the dryers.
Exhaust duct outlet should be checked periodically for
blockages, and if any found, removed.
IMPORTANT: A means of restraint must be used to prevent
straining of the gas line when the appliance is moved and to
keep the appliance upright when a load great enough to
topple it is applied to the open main door. An attachment
point has been provided in the outer top of the dryer for the
attachment of a restraint.
An external means of power removal (disconnect device)
must be provided by the installer.
CE ONLY
IMPORTANT: This appliance must only be installed and
operated in the country of destination indicated on the
dryer’s rating plate. If the appliance is to be installed and
operated in a country other than the one indicated on the
rating plate, a new rating plate must be obtained from
American Dryer Corporation.
IEC335 applies.
Warning
This appliance must only operate with the gas type
indicated on the dryer’s rating plate. If the
appliance is converted (gas type is changed), a new rating
plate must be obtained from American Dryer Corporation.
This appliance may cause spillage of products of
combustion from an open-flue appliance fitted in the same
room, and that such an appliance shall be tested for
clearance of products with the appliance in operation and
all windows and doors closed.
Disconnect power before attempting to reset any manual hi-
limit!
This dryer is equipped with two manual reset hi-limit
thermostats. The burner hi-limit is located in the top center
of the dryer behind the control door. The exhaust hi-limit is
located in the duct above the lint trap. The exhaust
thermostat must be removed to be reset.