ADB Stagelight EURODIM Twin Tech, Installation Manual

Page: 36 / 71

EURODIM TWIN TECH
User Manual - page 34
Issue 2.1 www.adbstagelight.com
7.4.1 Load terminals for 2 x 3 kW fluo modules
Each fluo dimmer comes with a dimmed output and a direct output on the second set of
output terminals. This can be compared to a standard 4 x 3 kW module. All 4 circuits need
to be patched to a DMX address.
Your Fluo circuitry should be connected as follows:
- fluo dimmer 1 DIM: dimmed phase output on output e.g. 15.1 LINE
- fluo dimmer 1 DIM: dimmed neutral output on output e.g. 15.1 NEUTRAL
- fluo dimmer 2 DIM: dimmed phase output on output e.g. 15.2 LINE
- fluo dimmer 2 DIM: dimmed neutral output on output e.g. 15.2 NEUTRAL
- fluo dimmer 1 DIRECT: direct phase output on output e.g. 15.3 LINE
- fluo dimmer 1 DIRECT: direct neutral output on output e.g. 15.3 NEUTRAL
- fluo dimmer 2 DIRECT: direct phase output on output e.g. 15.4 LINE
- fluo dimmer 2 DIRECT: direct neutral output on output e.g. 15.4 NEUTRAL
etc…
Tripping the MCB of a fluo dimmer will disconnect the dimmer and its associated direct
output. The direct output can be patched to an independent DMX channel.
Please also see attached drawing N° 3500.01.710
7.4.2 Load terminals for 10kW modules
Each 10 kW module is shipped with a special adaptor allowing the user to connect
cables with up to 25mm
² in diameter. The adaptor is screwed on to the edge of the cable
bar and the four cables are connected to the terminals leading to the module.
Attention: All four cables must be connected!