ADB Safegate RELIANCE IQ L-852G(L), User Manual

Page: 45 / 52

Prepare
1. Remove the water-tightness test valve cap.
2. Fill up the light fixture with compressed air (test pressure = 130 kPa).
Test
1. Put the light fixture in water, wait 3 minutes and check if air leaks out of the light.
a. If air leaks out of the light fixture (between bottom cover and top plate or between prism and top plate or water-
tightness valve and top plate), the light fixture is not watertight and must be repaired. Release the air from the light.
Disassemble the light fixture and re-check the mating surfaces and gaskets. Assemble the light fixture and perform the
water-tightness test again.
b. If the light fixture is water tight, release the compressed air from the light fixture and assemble the cap on the test
valve.
2. The light fixture is ready to be reinstalled in the field.
DANGER
Never exceed pressure of 150 kPa inside the light fixture as this may lead to personal injuries and damage the light.
6.2.4 Reset the Fail Open converter 2.3
Open
1. Disconnect and disassemble the light fixture.
2. Make sure you have a 2-way electrical shunt/jumper (2.54 mm/0.100” spacing), see
Figure 31 .
Figure 31: 2-way electrical shunt/jumper
Reset
1. Locate the 3-pin reset connector(s) on the converter. For the two-connector converter, there is one reset connector for
each side.
2. Place the 2-way electrical shunt (2.54 mm spacing) over the two pins marked red, see Figure 32 and Figure 33 .
Figure 32: Converter with 1 connector Figure 33: Converter with 2 connectors
3. Close the light fixture and connect it to a CCR.
4. Energize the light fixture until there is a steady light, then turn the CCR off and unplug the light fixture.
UM-0197, Rev. 1.0, 2019/11/19 39
Copyright
©
ADB Safegate, All Rights Reserved