4-9
Duralink64 Configurations for Windows
7
To add the second port, repeat Step 6.
Note:
To add multiple ports at one time, hold down the Ctrl
key, select the appropriate ports, and click Add. Only two
ports per group are supported for Failover.
To assign TCP/IP addresses to your ports, refer to
Assigning the
TCP/IP Address on page 4-16
.
Configuring the Failover Pair in Windows NT 4.0
To create Failover pairs in Windows NT 4.0, follow these steps:
1
From the Available Adaptec Ports list, select the port to be
designated as the primary port, and click Add. The port is
added under Primary Port field in the Pair Port list.
2
To assign a backup to the primary port, select the appropriate
port from the Available Adaptec Ports list, and click Add. The
port is added in the Backup Port list.
3
Click Apply.
4
O
PTIONAL
. Create another Failover pair by repeating Steps 1
through 3.
5
O
PTIONAL
. Remove a Failover pair by selecting the port from
the Primary Ports list; then click Remove. Both ports return to
the Available Adaptec Ports list. Click Apply.
