4-7
Duralink64 Configurations for Windows
Configuring the Ports in Windows NT 4.0
In the Adaptec New Hardware Found window, each port is
assigned to Autodetect, the default connection type that always
detects port connection and negotiates a compatible speed and
transmission mode.
To configure the ports in Windows NT 4.0, follow these steps:
1
In the Adaptec New Hardware Found window, make sure all
the DuraLAN NIC ports appear.
Note:
Generally, PCI Bus 0 is the PCI Bus on the
motherboard. For example, PCI Bus 1 or above is an
ANA-6x022 or ANA-6x044 NIC. The PCI Slot represents
the port on the NIC starting from the top. The top port
starts at PCI Slot 4.
2
In the New Adaptec NIC Ports Available window, available
Adaptec ports are listed. Select the appropriate port, and click
Apply
.
3
From the Connection Types: drop-down list, select and click
the connection type for your network—or select Autodetect
Default Connection
. The connection type will automatically
be applied to the list of Ports below the Connection Type area.
For descriptions, see Connection Types
on page A-2
.
4
Repeat Steps 2 and 3 for each existing port.
5
When you are done, click OK.
