Adaptec ANA-62000, User Manual

Page: 91 / 202

8-9
Duralink64 Port Aggregation for Windows NT
Note: The group name may be up to 20 characters. If
you skip this step, the system assigns a default group
name (GroupX).
2
In the Link Aggregation Type field, click the appropriate link
type. For a description of Adaptec’s Port Aggregation, see
Chapter 2, Introduction to Duralink64 Port Aggregation.
3
In the Available Adaptec Ports box, click the available port to
add to the group, and then click Add.
4
Repeat step 3 for each additional port.
Note: You must assign the same connection type to
each port in the same group.
O
PTIONAL
. To remove a port from the group, click the
appropriate port from the Group Ports box, then click Remove.
5
When you are finished configuring the group, click Apply.
6
To create another group, repeat steps 1 through 5.
7
If you want to rename a group:
a
Select the default group name in the Group(s) list box.
b
Type the new name.
c
Click Apply.
8
When you are finished configuring all groups, click OK.
9
If SNMP is not set up, you will receive the Setup Message
below. Click OK
.
Figure 8-7. This message may be ignored during this installation