2000 American Honda Motor Co., Inc. – All Rights Reserved
4 of 10
BII 22288 (0010)
12. Route the terminal ends of the disarm switch
through the hole you just drilled and secure the
disarm switch using the 12 mm nut, and washer
provided. Tighten the nut securely.
12 mm NUT
WASHER
12 mm HOLE
DRIVER’S DASHBOARD
LOWER COVER
DISARM SWITCH
13. Firmly push the terminals of the disarm switch into
the 3-pin connector provided until they click into
position. Pull gently on the wires to verify that they
are locked in the connector. Make sure that the
terminals are positioned properly, and then lock
the connector.
3-PIN CONNECTOR
Insert the tabs into the
grooves, slide the lock
toward the front, and
press down on the end.
BLACK
WIRE
BLUE WIRE
DISARM
SWITCH
Push the terminals
into the connector until
they click into position.
14. Position the control unit on the control unit
bracket, and install the two washer-screws.
CONTROL UNIT
BRACKET
HOLE
ANTENNA
WIRE TIE
WITH CLIP
WASHER-SCREWS
CONTROL
UNIT
15. Secure the antenna to the control unit with the
wire tie with clip, and push the clip into the hole in
the control bracket.
16. Position the control unit bracket assembly on the
vehicle bracket, and install the two
6 x 16 mm washer-bolts and the 8 x 16 mm
washer-bolt.
STEERING
SHAFT
6 x 16 mm
WASHER-BOLTS
CONTROL
UNIT
CONTROL UNIT
BRACKET
8 x 16 mm
WASHER-BOLTS
VEHICLE
BRACKET
