2000 American Honda Motor Co., Inc. – All Rights Reserved
8 of 10
BII 22288 (0010)
35. Check that all wire harnesses are routed properly
and all connectors are plugged in.
36. Reinstall all removed parts, except the driver’s
dashboard lower cover.
37. Route the 3-pin connector from the disarm switch
on the driver’s dashboard lower cover over the
knee bolster to the 3-pin connector blue-taped to
the vehicle harness behind the fuse box. Remove
the blue tape to free the connector, and plug the
3-pin connector from the disarm switch into this
connector.
KNEE BOLSTER
3-PIN
CONNECTOR
BLUE
TAPE
FUSE
BOX
DISARM SWITCH
DRIVER’S
DASHBOARD
LOWER COVER
VEHICLE
WIRE
HARNESS
38. Reinstall the driver’s dashboard lower cover.
39. Route the security system harness between the
steering shaft and vehicle harness and plug its
22-pin connector (marked A) into the control unit.
Press the wire harness clip on the security system
harness into the hole in the control unit bracket.
VEHICLE
HARNESS
STEERING SHAFT
CONTROL
UNIT
SHORT
WIRE TIE
SECURITY SYSTEM
HARNESS 22-PIN
CONNECTOR
(MARKED A)
WIRE HARNESS
CLIP
40. Secure the security system wire harness to the
vehicle harness with one short wire
tie as shown.
41. On the front driver’s door, remove the cap from
the inner handle trim, and remove the self-tapping
screw concealed under the cap.
INNER HANDLE
TRIM
DOOR
LINING
CONNECTOR
DOOR
HANDLE
CAP
SELF-TAPPING
SCREW
42. Pull the door handle, and remove the inner handle
trim by sliding it rearward.
43. Remove the self-tapping screw fastening the door
pull pocket and remove the pocket by pulling it
upward.
RETAINING CLIP
D
3 DOOR (8)
D
4 DOOR (7)
DOOR LINING
DOOR
PANEL
SELF-TAPPING
SCREW
CONNECTORS
CLIP
TWEETER
DOOR LINING
DOOR PULL
POCKET
RETAINING
CLIP
(4 DOOR
ONLY)
44. Remove the clip from the front of the door lining,
then pry up on the eight retaining clips on the
back of the door lining.