2000 American Honda Motor Co., Inc. – All Rights Reserved
2 of 10
BII 22288 (0010)
Wire tie with clip
2 Flange bolts 6 x 12 mm
Flange nut
Door harness
TOOLS AND SUPPLIES REQUIRED
PhilIips screwdriver
Stubby PhilIips screwdriver
Flat-tip screwdriver
Eye protection (face shield, safety goggles, etc.)
Drill
5.5 mm, 10 mm and 12 mm Drill bits
Tape measure
Ratchet
10 mm and 17 mm Socket
10 mm and 12 mm Combination wrenches
Diagonal cutters
Utility knife
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your car. These procedures should
not be attempted by “do-it-yourselfers.”
1. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the three screws, and release the six
clips by pressing the steering upper and lower
covers in the areas shown. Remove the covers.
UPPER
STEERING
COVER
LOWER
STEERING
COVER
SCREWS
4. Measure and mark the upper steering column
cover.
CENTER
5.5 mm
DRILL BIT
UPPER STEERING
COLUMN COVER
5. While wearing eye protection, lightly center-punch
the mark; then drill a 5.5 mm hole through the
cover. Remove all burrs.