2000 American Honda Motor Co., Inc. – All Rights Reserved
6 of 10
BII 22288 (0010)
22. Position the 5-pin relay on the relay bracket, and
install one 6 x 12 mm flange bolt and the flange
nut. Tighten the bolt securely.
5-PIN RELAY
RELAY
BRACKET
6 x 12 mm
FLANGE BOLT
FLANGE NUT
23. Position the relay bracket on the cruise control
unit bracket, and secure it with the other 6 x 12
mm flange bolt. Tighten the bolt securely.
6-PIN
CONNECTOR
RELAY
BRACKET
6 x 12 mm
FLANGE
BOLT
AUTO CRUISE
CONTROL UNIT
5-PIN RELAY
4-PIN CONNECTOR
BLUE TAPE
SHORT
CONNECTOR
6-PIN CONNECTOR
VEHICLE’S
HARNESS
24. Locate the 4- and 6-pin connectors blue-taped to
the vehicle harness, and remove the blue tape to
free the connectors. Before connecting it, remove
the short connector from the 6-pin connector; plug
this connector into the relay.
25. Remove the bolt that fastens the bottom of the
cruise control unit bracket, insert the end of a
flat-tip screwdriver to release the lock, and
disconnect the 14-pin connectors of the vehicle
harness under the bracket. Connect the security
system wire harness 14-pin connector (marked C)
in between the 14-pin connectors you just
disconnected.
NOTE: If the vehicle you’re working on is not
equipped with cruise control, the 14-pin connector
is attached to the kick panel.
SECURITY SYSTEM
WIRE HARNESS
CONNECTOR
(MARKED C)
14-PIN
CONNECTOR
LOCK
BOLT
CRUISE
CONTROL
UNIT
FLAT-TIP
SCREWDRIVER
BRACKET
VEHICLE HARNESS
VEHICLE
HARNESS
SHORT WIRE TIE
26. Between the two connectors, secure the security
system wire harness to the vehicle harness with
one short wire tire, as shown.
27. Reinstall the cruise control unit bracket and
tighten the bolt.